MS3Pro 1984-1987 Buick Grand National Plug and Play

The MS3Pro Buick Grand National Plug and Play (P/N: MSPNPPro-GNX8487) Fits 1984-1987 Buick Regal with the 3.8 Turbo V6, including Grand National, T-Type, and GNX.

Buick Grand National Plug and Play Model Features:

• Fully Plug and Play Installation – No wiring required for basic functionality.
  • Average install time is under 1 hour!
• Base map is pre-loaded to help your engine start on the first turn of the key
• Real time tuning and data logging with a laptop connection
• 8 GB internal data logging with built in SD card
• Supports most aftermarket wideband sensors
• Fits directly in the stock ECU pocket in the kick panel. No extension harnesses required!

Fully Tunable Engine Control!

• 16×16 Fuel Tables allow high resolution tuning
• 16×16 Ignition Tables
• Multiple Acceleration enrichment strategies
• Closed Loop Idle Speed Control
• Air Conditioner Control
• 6 sequential fuel injector channels with individual trim tables
• Onboard peak and hold drivers support both high and low impedance injectors – No external ballast resistor is needed!
• Allows removal of stock MAF sensor
• Use either factory C3I ignition or coil per plug conversions
• Torque converter lock up control
• Boost control using stock or aftermarket boost control solenoids

Advanced Feature Set (Included!)

• 12×12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
• Multiple traction control strategies
• Built-in 3-step rev limiter / launch control with flat shift and burnout rev limiter
• Time based timing / boost increase after launch
• Real time barometric correction
• Internal 4-bar MAP sensor reads up to 44PSI of boost
• Overboost protection
• CO2 based boost control
• Set boost by RPM and throttle, ground speed, or gear (Improve performance with EBC solenoid kit
• Rally style anti lag
• Water injection control – on/off or variable
• Knock sensor input with adjustable sensitivity, crank angle windowing, and more (advanced features require bypassing ESC module)
• Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
• Input for flex fuel sensor – switch between E85 and gasoline on the fly!
• CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller if swapping to a 4L80E, Additional Sensors…..the possibilities are limitless!

What you get in the box:

• MS3Pro Plug in ECU for Buick Grand National
• RS232 tuning cable
• Tuning Software and Documentation on USB memory stick with three base maps included
• 6′ Vacuum Hose for MAP Signal and ‘T’ fitting
• Registered version of TunerStudio and MegaLog viewer included

Add an optional USB tuning cable